1982 Yamaha IT465

Description

New: Cyl.bored, new Wiseco piston kit 86.5mm
Top bearing
Boyesen reeds
Carb kit
Athena gasket set
Amsoil gear oil
NGK plug
Air filter
Petcock
Shifter shaft seal
Fork seals-rebuilt @Pete's Cycle-Balto.MD
Heavier Yama-Lube fork oil-no air needed
Frt, Rr AllBalls wheel bearings
AllBalls swing-arm bearings
DID Gold chain
Clarke 4g tank
Brake pads
Yamaha seat cover-not installed
DC plastic kit-not installed
Wicked Tough decal set-not installed
Zero hours on all above parts. Zero hours on fork rebuild, cylinder bore, carb rebuild and bearing replacements. Final bore for this cylinder. Receipts for much, not all.
OEM plastics aren't too bad, new DC kit and WT stickers for restoration. New Clarke 4g tank. Original tank is tanked (included). New seat cover for resto, good cushion and pan.  Some spare parts.
Pipe has been altered at the muffler as seen in pic. Spark arrestor still fits.
Rr. fender/frame bar is missing paint in 2 small spots, as seen in pic, most likely from being bent back into place after an over-wheelie.
Ding on a cooling fin as seen in pic.
Kick-stand tab broken off. A tab would need welded on to install a OEM kick-stand
.
Cash payment due upon pick-up.  Thanks